Size：35.6 * 29 mm

Weight： 8.5 grams

Precision： 250 nanoseconds

Voltage： 3.3-12V Support for rever.se protection

Conversion speed: Interrupt decoding without waiting after the signal is collected

pin header: 2.95 mm longitudinal spacing receiver pin header

Function

Mode 1: PWM signal converted into PPM signal and sbus signal. PWM signal analysis.

Mode 2: Two-way ppm signals converted into PWM signals and sbus signals. Two-way PPM signal analysis.

Mode 3: Sbus signalconverted into PWM signal and a two-way ppm signal. Sbus signal analysis.

Analytical capabilities

Simultaneous analysis of 20-channel PWM signal

Simultaneous analysis of 2-channel PPM signal, PPM signal can contain 4-20 proportional channels, Up to 40 signals can be identified.

1-channel Sbus signal analysis, including 16CH proportional channels, 2CH switch channelsand receiver status

Mode Setting method

Because some control board has bidirectional communication function, use automatic detection can cause the signal misjudgment, so in order to guarantee the reliability, this product chooses the input signal using the method of button setting.

The front of the product has three LEDs, representing the PWM input mode, ppm input mode and Sbus input mode respectively.

Press and hold the Settings button then power the conversion board, three lights flashing at the same time, release the button at this time to enter the setup mode.

Press the button, the function mode will switch once, and the corresponding LED lighted, select the desired input signal then power off ,it can save conversion mode automatically.

Interface

W1-W20 represents PWM1 to PWM20, pulse-width input and output, bidirectional interface

PP1-PP2 represents PPM1 and PPM2, pulse width modulation input and output, bidirectional interface

SB represents Sbus interface, digital bus input and output, bidirectional interface

UART represents TTL serial output baud rate 115200, 8N1, one-way output interface